9. Extraction of a front epiploon of a bent shaft by means of a special remover - try not to damage a surface of a wrist pin of a shaft.
Installation:
1. Smooth out an epiploon nest, having removed with its surfaces all traces of a material of an old layer pad and corrosion. Establish a new epiploon in a nest sponges (usually from sponges the broad spring) inside (to the engine is established). The oil Small amount put on external edges of an epiploon will facilitate installation - however be not overzealous in greasing.
2. Begin to knock an epiploon in a nest before its full landing in it by means of the big replaceable head and a hammer (the six-cylinder engine see an illustration in Head Rjadnyj). A head pick up so that its outer diameter was equaled to an epiploon outer diameter. Track, that the new epiploon “has sat down” in a nest against the stop in a cover flange.
3. Check up a condition of a surface of the snubber of shifting jerkss contacting to an epiploon. If the epiploon has developed a flute in a surface, the snubber can be restored by means of the special liner - address in a car-care centre workshop.
parts-diagram-for-jeep-grand-cherokee
